Hi Dear Oceanographers members

I need your help. please Could anyone give me response? my thesis can not go on without resolving this issue that I have.

Bathymetry file where land points were negative and wet points were possitive was edited. Finally, after the editted bathymetry file, swn file, and wnd file (wind field data) are prepared, they are all placed in the same directory. then SWAN was run in MS-DOS. all these files and output files are enclosed;


http://rapidshare.com/files/443584582/Swan_48.rar

I think that there is still a logical problem.

because, after SWAN was run in MS-DOS, SWAN generated real numbers for land points that they are negative in the bathymetry (input file). contrary to expectations, SWAN did not generated real numbers for wet points that they are possitive in the bathymetry (input file).


What can be the reason of this problem? Can you please check the my input and output files?

I tried quite a few, but I did not resolve the problem. if you can help me about this problem, I will be very happy.

best regards

Adem Akpınar
Phd Students
Karadeniz Technical University
Civil Engineering Department

Lecturer Adem Akpınar
Gümüşhane University
Faculty of Engineering
Civil Engineering Department
29100 Gümüşhane / Turkey
ademakpinar@hotmail.com
aakpinar@ktu.edu.tr